Replacement Guides RSS

Introduction Use this guide to replace the PlayStation 3 Slim's single cooling fan.   Step 1 Top Cover Carefully peel the warranty sticker up off the lower case to reveal a hidden screw cover. Turn the PS3 over and lay it on its backside. Carefully peel the warranty sticker up off the lower case to reveal a hidden screw cover. To avoid activating the VOID that may come up, heat the sticker carefully to remove and replace it cleanly.   Step 2 Use the flat end of a metal spudger to pry up the seven screw covers around the edge...

Introduction This guide will show the users how to remove the Wi-Fi antennas of the PlayStation 3 Super Slim. The step will show users how to remove the mounted antennas. After, the guide will go into the removal of the antennas' wires from the sockets on the motherboard. Step 1 Power Supply Unit The bay cover is found on the right side of the device. Remove the side HDD bay cover by sliding the panel towards the back of the device. The bay cover is found on the right side of the device.   Step 2 Remove the blue 7.9mm...

Introduction If you are replacing the power supply unit, that means that the device is not reliably receiving power and therefore is not operating properly. Before you begin this guide, make sure that you have the proper tools (as listed below), some free time, and a clean and clutter-free space to work. When following the steps to this guide, be sure to be gentle when applying pressure to different panels or components as they may bend or break easily. Otherwise, take your time and make sure to read the steps carefully as you work through your power supply replacement!  ...

Introduction This guide starts with the process of opening up the Playstation 3 Super Slim and moves on to remove the optical drive in its entirety. If your PlayStation 3 Super Slim is not reading disks properly or you know that the problem with your device is due to a faulty optical drive, consider following these steps to replace it. Before following the steps to replace the optical drive, be sure that you have all the correct tools necessary, enough time to do the job carefully, and an uncluttered and clean workspace. When following the steps, make sure that you...

Introduction How to disassemble and change the Laser Unit.   Step 1 Laser Unit / Deck replacement Turn off the console and disconnect all cables.   Step 2   You must remove the warranty sticker and 4 screws.   Step 3   After removing HDD bay cover, you will see another 3 screw.   Step 4   Push there to release and remove upper back bezel.   Step 5   The upper front bezel is harder to remove.   Step 6   Remove 7 screws to release top cover.   Step 7   Disconnect two flex-cables and move the Laser...