Xbox 360 Wireless Controller Bumper Panel Replacement

Main guide photoIntroduction

Can't cycle through your grenades in Halo 3? Install some new bumpers and stick your enemies!

Step 1 Battery
Image 1/2: Remove the battery holder from the controller.

Depress the battery release button on the top of the controller.
Remove the battery holder from the controller.
The standard option for Xbox 360 Wireless Controllers Battery Packs is AA batteries. A rechargeable battery is also available, but both battery options are removed from the controller in the same way.

Step 2 Rear Case
Image 1/1: Use a pair of tweezers to peel the barcode sticker from the battery compartment.

Use a pair of tweezers to peel the barcode sticker from the battery compartment.
Use a pair of tweezers to peel the barcode sticker from the battery compartment.

Step 3
Remove the seven 9.3 mm T8 Security Torx screws securing the rear case to the front case.
5 comments

Image 1/1:



Step 4
Image 1/2: Rotate the spudger toward the front of the controller, prying the two cases apart.


Insert a Spudger between the front and rear cases along the left edge of the controller.
Rotate the spudger toward the front of the controller, prying the two cases apart.
Rotate the spudger toward the front of the controller, prying the two cases apart.

Step 5

Image 1/2: Rotate the spudger toward the front of the controller to pry the two cases apart.
Insert a spudger between the front and rear cases, near the headphone jack.
Rotate the spudger toward the front of the controller to pry the two cases apart.

Step 6
Image 1/2: Lift the battery compartment away from the headphone jack, separating the rear case from the front case and logic board.


Grasp the controller by the battery compartment and the headphone jack.
Lift the battery compartment away from the headphone jack, separating the rear case from the front case and logic board.
The battery contact springs are held in place by slots in the battery housing in the rear case. Be sure to realign them properly during reassembly.

Step 7 Vibration Motors
Image 1/2: Lift the vibration motor out of the front case.


Use the flat end of a spudger to remove the vibration motor cable, moving it upward from its socket on the logic board.
Lift the vibration motor out of the front case.

Step 8

Image 1/2: The right motor has significantly more counterweight than the left motor.

Remove the vibration motor from the other side of the controller using the same method previously described.
The right motor has significantly more counterweight than the left motor.


Step 9 Logic Board
Image 1/2:


Lifting from the headphone jack and power plug, remove the logic board from the front case.

Step 10 Bottom Panel
Image 1/2:

Lift the bumper panel off of the front case.

Author
Brett Hartt
Member since: 04/12/2010
95,713 Reputation
187 Guides authored

 


0 comments

Leave a comment

Please note, comments must be approved before they are published