May 26, 2017

PSP Go Back Cover Replacement

Introduction

This guide shows you how to remove the PSP Go's back cover.

Step 1 Back Cover

Image 1/2: Rotate the PSP so you can see the top of the device.

Unscrew the four Phillips screws on the back of the PSP Go.
Rotate the PSP so you can see the top of the device.
Unscrew the two Phillips screws next to the volume buttons.

Step 2

Image 2/2: Be careful not to rotate the back cover from the bottom, as you will break the plastic screw holes on top of the device.

Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.
Open the back cover by gently lifting the right side, and rotating it to the left side (as if you were opening a book).
Be careful not to rotate the back cover from the bottom, as you will break the plastic screw holes on top of the device.

Author
Miroslav Djuric
133,447 Reputation
169 Guides authored