PSP 300x Casing Replacement

Main guide photo

Introduction

 

Step 1 Battery
Image 1/3: Lift and remove the battery cover to reveal the battery.

Place the PSP face down and locate the battery cover on the left side of the device.
Lift and remove the battery cover to reveal the battery.
Remove the battery.

Step 2 Casing


Image 1/1:

Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.

 

Step 3


Image 1/2: Two are located behind the battery's warranty sticker.

Unscrew all four screws from the back of the PSP with the Phillips #00 Screwdriver.
Two are located behind the battery's warranty sticker.
Two are located on the right side of the PSP.

 

Step 4


Image 1/1:

Next, unscrew the two screws located at the top of the PSP.

 

Step 5


Image 1/1:

Then, remove the single screw from the bottom edge of the PSP (which is positioned next to the barcode).

 

Step 6


Image 1/2: Remove the front casing completely.

Slide the spudger in between the outer casing of the PSP, beginning at the "R" shoulder button, and gently pry off the casing.

Remove the front casing completely.

Steps for replacing the outer casing of a Sony PSP-3000.

 

Author
pepe32290
Member since: 10/19/2009
955 Reputation
4 Guides authored


0 comments

Leave a comment

Please note, comments must be approved before they are published