PSP 2000 Memory Stick Slot Replacement

Main guide photo

Introduction

Is your Memory Slot just not performing as well as it used to? Fix it!

 

Step 1 Battery


Image 1/3: Locate the battery door and open.

Place PSP face down, so that the UMD Drive is facing upwards.
Locate the battery door and open.
Remove the battery from inside.

 

Step 2 Front Casing


Image 1/1: Locate the sticker in the battery compartment labeled: ''"En: Warranty Void if Seal Damaged."''

This step requires the removal of the warranty sticker. Removing the sticker will void the warranty.
Locate the sticker in the battery compartment labeled: "En: Warranty Void if Seal Damaged."
Remove the sticker using the PSP Opening Tools.
Under the sticker is a 5mm Phillips screw needed in the next step.

 

Step 3


Image 1/2: If the screws stick in the case, you can use a magnetized screwdriver to draw them out.

Remove four 5 mm Phillips from the case.
If the screws stick in the case, you can use a magnetized screwdriver to draw them out.

 

Step 4


Image 1/2: Two 4 mm Phillips

Remove the following screws from around the bezel:
The two shorter 4 mm screws are on the top of the PSP; the longer 5 mm screw is on the bottom.

 

Step 5


Image 1/2: Start on the right hand side of the PSP bezel, and carefully work the tool around the side.

Gently pry the front bezel away from the casing using a PSP opening tool.
Start on the right hand side of the PSP bezel, and carefully work the tool around the side.
If you want to clean the control buttons or D-pad, you can easily pop them out once the faceplate is off and wipe them clean.

 

Step 6 Display

Image 1/3: A ribbon cable connects the home bar to the logic board.  Be careful not to damage the cable when removing the bar.


Remove the home bar by gently prying on the left and right sides of it with the opening tools. Lift the bar out of the device.
A ribbon cable connects the home bar to the logic board. Be careful not to damage the cable when removing the bar.

 

Step 7

Image 1/3: There is another ribbon cable attached to the bottom of the LCD. Be careful not to damage either of the connectors when removing.

With the home bar out of the way, gently pry up the display using the opening tools.
There is another ribbon cable attached to the bottom of the LCD. Be careful not to damage either of the connectors when removing.
Lift the black tabs of the ribbon cable connectors using a opening tool. Pull the ribbons out towards the bottom of the PSP to disconnect.
Gently lift out the display.

 

Step 8 Memory Stick Slot


Image 1/3: Slide off the left trigger along with the plastic bracket underneath.

Remove two 4.5 mm Phillips screws from the left-hand side of the PSP.
Slide off the left trigger along with the plastic bracket underneath.
Carefully pry off left trigger button using opening tools.
The button is adhered to the body. It can be re-adhered with hot glue after being pried-up, if necessary.

 

Step 9


Image 1/2: Gently remove the memory card slot by pulling it straight out.

Use an opening tool to lift up the brown tab on the connector and remove the cable horizontally.
Gently remove the memory card slot by pulling it straight out.

 

Author
espinks
Member since: 10/18/2009
2,360 Reputation
5 Guides authored


0 comments

Leave a comment

Please note, comments must be approved before they are published