Introduction
Step 1PlayStation 4 Camera Teardown
There are two PH0 Screws in the socket which hold the cable.
Unscrew two PH0 Screws and pull off the cable holder.
Step 2
The next two PH0 Screws are located BEHIND the two polycarbonate-plates of the two camera-lenses. Take a sharp tweezer and stab under that plate. The plates are glued with a sticky tape to the housing. These plates are very fragile and will break if handled incautious.
Step 3
Ja there is one.
This was the easy part.
Step 4
There are many clips in there.
Step 5
Encore two photos where to locate these nasty clips
Step 6
The other half of the housing is attached to a solid U-Frame with the electronics.
There are four silver screws, PH0.
Four microphones, two with black/yellow cables and two with black/red wiring.
Step 7
The backside of the U-frame. The cable is not soldered, there is a plug.
Step 8
6 PH1 screws. Take a small magnet to hold them.
Step 9
The connector of the mikrophone-array
Step 10
The lenses, plastic, glued tight.
NOT ADJUSTABLE.
Step 11
Backside, two small PH0 at each CCD. But the Cameramodules are clued to the board,too - without destruction, you can not open it.
I want to save it as spare-part, so i don't want to open it. So here is finito capito. :) Thanks for watching...
Step 12
It's an USB3 cable without green/white Pimf. There are three SEPARATE ISOLATED metalfoil shields with wire, red-black-power and two Pimf yellow/blue and orange/green. So ja, thats it. Paulaner.
Author
Schwarzstein
Member since: 07/15/2013
1,995 Reputation
16 Guides authored