Introduction
How to disassemble and change the Laser Unit.
Step 1 Laser Unit / Deck replacement
Turn off the console and disconnect all cables.
Step 2
You must remove the warranty sticker and 4 screws.
Step 3
After removing HDD bay cover, you will see another 3 screw.
Step 4
Push there to release and remove upper back bezel.
Step 5
The upper front bezel is harder to remove.
Step 6
Remove 7 screws to release top cover.
Step 7
Disconnect two flex-cables and move the Laser Unit. Remove the two screws and the small cable and then take out the Power Supply Unit.
Step 8
To release the laser unit disconnect this flex-cable.
Step 9
One flex-cable, for rubbers and the metal bezel.
Step 10
Disconnect this flex-cable and attach it to the new spare part. Let's start assembling.
Step 11
Assembling, assembling...
Step 12
Let's test the device before fully assembling it.
Did you do it successfully?
Please SUBSCRIBE to my channel ツ
CONCLUSION
To reassemble your device, follow these instructions in reverse order.
Author
ZFix
Member since: 12/09/2013
122,367 Reputation
343 Guides authored