Nintendo Wii Faceplate Replacement

Introduction

Use this guide to replace your Wii's faceplate. Replacing the faceplate will provide new blue LEDs that light up around the optical drive opening.

Step 1 Faceplate
Image 1/2:


Use a metal spudger to remove the white plastic screw covers stuck to the lower case near the front of the Wii.

Step 2
Image 1/1:
Remove the two 8.3 mm Tri-Wing screws hidden under the covers you just removed.

Step 3

Image 1/1:
Remove the single 5.9 mm Phillips screw under the controller port door nearest the faceplate.

Step 4
Image 1/1:
Use a metal spudger to remove the rubber foot stuck to the side of the Wii near the DVD drive opening.

Step 5
Image 1/1:
Remove the single 5.9 mm Phillips screw hidden under the foot you just removed.

Step 6

Image 1/2: Use a pair of tweezers to disconnect the LED cable's plastic connector from the motherboard.

Carefully pull the faceplate away from the front of the Wii.
Use a pair of tweezers to disconnect the LED cable's plastic connector from the motherboard.
Remove the faceplate.

Author
Andrew Bookholt
445,649 Reputation
868 Guides authored


0 comments

Leave a comment

Please note, comments must be approved before they are published