Introduction
Be the envy of onlooking gamers with a shiny new rear bezel on your DSi XL.
Step 1 Rear Bezel
Use a push pin to remove the four plastic screw covers on the front bezel.
Step 2
Remove four Phillips screws securing the front bezel to the rear bezel.
Step 3
The rear bezel will move only about 2 mm.
Using two hands, gently slide the rear bezel upwards.
The rear bezel will move only about 2 mm.
Step 4
Rotate the spudger away from the DSi XL, prying the two bezels apart.
Insert a spudger into the gap between the front and rear bezel
Rotate the spudger away from the DSi XL, prying the two bezels apart.
Step 5
In the same manner as described above, continue prying along the top edge of the front and rear bezels.
Step 6
Do not attempt to completely remove the rear bezel yet. It is still attached to the front bezel by the rear-facing camera.
Separate the rear bezel from the front bezel.
Do not attempt to completely remove the rear bezel yet. It is still attached to the front bezel by the rear-facing camera.
Step 7
Remove the rear bezel.
Use the flat end of a spudger to pry the rear camera off the rear bezel.
Remove the rear bezel.
Author
Matt Newsom
Member since: 01/05/2010
29,318 Reputation
68 Guides authored
