Nintendo DSi XL Lower Case Replacement

Introduction

Replaced your broken or scratched up lower case with a shiny new one.

 

Step 1 Battery

 

Lift the battery cover off the back of the DSi XL.

Remove the two Phillips screws securing the battery cover to the back of the handheld console.

Lift the battery cover off the back of the DSi XL.

 

Step 2

Lift the battery from the DSi XL.

 

Step 3 Lower Case

Remove the four rubber screw covers on the lower case by prying them up with a push pin.

 

Step 4

 

Four silver 5.3 mm screws

Remove the following seven Phillips screws that secure the lower case to the rest of the DSi XL:

Four silver 5.3 mm screws

Two black 5.3 mm screws

One black 2.5 mm screw

 

Step 5

 

Insert a spudger between the upper and lower case at the bottom left corner of the DSi.

Turn the DSi XL over, and open the display.

Insert a spudger between the upper and lower case at the bottom left corner of the DSi.

Slide the spudger along the bottom edge of the upper case to release the latches securing the upper case to the lower case.

 

Step 6

 

Lift the lower case from the front edge.

Close the display and turn the DSi XL over.

Lift the lower case from the front edge.

Rotate the lower case away from the DSi.

The lower case cannot be completely removed yet, since it is still connected to the motherboard.

 

Step 7

 

Pry the volume button/left shoulder button connector off its socket on the motherboard with a spudger.

Using a spudger, pry the SD card/right shoulder button connector off its socket.

Pry the volume button/left shoulder button connector off its socket on the motherboard with a spudger.

 

 Author

David Hodson
Member since: 04/13/2010
120,054 Reputation
132 Guides authored


0 comments

Leave a comment

Please note, comments must be approved before they are published