Step 1 Remove the external screws
Place the Game Boy Pocket face-down on a clean, flat surface.
Use a Y1 tri-wing screwdriver and turn counterclockwise to remove the four external screws.
Use a Y1 tri-wing screwdriver and turn counterclockwise to remove the two screws inside the battery compartment
Step 2 Open the device
Place your hands on the front and back covers of the Game Boy Pocket, and carefully separate the device.
Set the back cover aside. You will need it to reassemble the device
Step 3 Remove the motherboard screws
Use a Phillips #1 screwdriver and turn counterclockwise to remove the three screws on the motherboard.
Step 4 Remove the clip securing the ribbon cable
Use a plastic opening tool to dislodge and remove the clip securing the ribbon cable.
Make sure you apply pressure on both sides of the clip to loosen it.
Step 5 Dislodge the ribbon cable
Use a plastic opening tool to dislodge the ribbon cable.
Be gentle to prevent tearing the ribbon.
Step 6 Remove the motherboard
Grab the black piece protruding from the motherboard, and lift up to remove the motherboard.
Set the motherboard aside. You will need it to reassemble the device.
Step 7 Remove the buttons
Use your fingers to remove the three silicone button covers
Use a plastic opening tool to remove the buttons.
Step 8 Remove the LCD screen
Use a plastic opening tool to lift the LCD screen away from the front cover.
Use your fingers to remove the LCD screen.
Set the LCD screen aside. You will need it to reassemble the device.
Step 9 Replace the front housing
Replace the front housing.
Author
Adriana Rahrig
Member since: 10/07/2014
802 Reputation
5 Guides authored
