National Holiday from 9/29- 10/5, orders will be shipped after 5th Oct.

HOLIDAY NOTICE: ORDERS DURING THE SPRING FESTIVAL HOLIDAY OF JAN. 14TH TO JAN. 29TH WILL BE SHIPPED SEQUENTIALLY FROM JAN. 30TH. THANKS FOR YOUR SUPPORT!

Game Boy Batteries Replacement

Introduction

This guide will illustrate how to replace the batteries in a Game Boy system.

Step 1 Batteries
Image 1/2:

    Switch your Game Boy off and remove the cartridge.


Step 2

Image 1/3: The release latch is a plastic spring clip. If your Game Boy is getting on in years, be careful as the plastic may be brittle.
 The release latch is a plastic spring clip. If your Game Boy is getting on in years, be careful as the plastic may be brittle. Image 2/3: When you're replacing the cover, be sure to get its two plastic tabs into the slots in the bottom of the battery compartment before pushing the cover back in place. Image 3/3: When you're replacing the cover, be sure to get its two plastic tabs into the slots in the bottom of the battery compartment before pushing the cover back in place.

    Use a fingernail (or small coin) to push down on the battery door latch and remove the battery door.

        The release latch is a plastic spring clip. If your Game Boy is getting on in years, be careful as the plastic may be brittle.

        When you're replacing the cover, be sure to get its two plastic tabs into the slots in the bottom of the battery compartment before pushing the cover back in place.


Step 3

Image 1/2: Dispose of used batteries properly!
 Dispose of used batteries properly! Image 2/2: Remove the batteries from your Game Boy before storing it for more than a month or so.

    Use a fingernail to pry each battery outward from the positive (+) terminal to remove them.

        Dispose of used batteries properly!

        Remove the batteries from your Game Boy before storing it for more than a month or so.


Author
Andrew Tramposch
Member since: 06/24/2010
1,344 Reputation
6 Guides authored


0 comments

Leave a comment

Please note, comments must be approved before they are published