May 27, 2017

PSP Go Top Cover Replacement

Introduction

Use this guide to replace your PSP Go's top cover.

Step 1 Back Cover

Image 1/2: Rotate the PSP so you can see the top of the device.

Unscrew the four Phillips screws on the back of the PSP Go.
Rotate the PSP so you can see the top of the device.
Unscrew the two Phillips screws next to the volume buttons.

Step 2

Image 1/2: Open the back cover by gently lifting the right side, and rotating it to the left side (as if you were opening a book).

Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.
Open the back cover by gently lifting the right side, and rotating it to the left side (as if you were opening a book).
Be careful not to rotate the back cover from the bottom, as you will break the plastic screw holes on top of the device.

Step 3 Top Cover

Image 1/1:

Pull the top cover upwards gently from its housing.

Author
Walter Galan
482,543 Reputation
1,963 Guides authored